Threaded Sleeve SW-701

The sleeve is made to meet your requirements. The standard sleeve material is carbon steel, but stainless steels and higher strength steels are also available on request. We furnish the sleeves without wrench flats unless specified on the order. Please indicate dimensions across the flats, the number of sides, and the location on the fitting.

Please specify the Ls, Lt and D.

To determine the thread length (Lt), use the minimum dimensions needed. This allows us to use existing qualified designs. The standard thread used is Right Hand National Coarse Class 2A, but other threads are available on request.

You may order custom designs with different fitting lengths if you want, but that may reduce the assembly's rated capacity.

  • Maximize the length adjustment of your assembly at the point where a wire rope is attached
  • Equivalent to SA155 Series

Dimensions for Threaded Sleeve SW-701
Dash No. Rope Dia. D Lt Approx. Ls As
3 3/32 1/4 1/2 1 1/4
4 1/8 1/4 3/4 1 1/4 1/4
5 5/32 5/16 1 1 1/2 5/16
6 3/16 3/8 1 1/4 1 3/4 3/8
7 7/32 7/16 1 1/4 2 7/16
8 1/4 1/2 1 1/2 2 1/4 1/2
9 9/32 9/16 1 1/2 2 1/2 9/16
10 5/16 5/8 1 3/4 3 5/8
12 3/8 3/4 2 3 1/2 3/4
14 7/16 7/8 2 1/4 4 7/8
16 1/2 1 2 1/2 4 1/2 1
18 9/16 1 1/8 2 3/4 5 1 1/8
20 5/8 1 1/4 3 5 1/2 1 1/4
24 3/4 1 1/2 4 7 1 1/2
28 7/8 1 3/4 5 8 1 3/4
32 1 2 6 9 2

All dimensions are in inches.

Special constructions and diameters available upon request – please contact us directly.